Two-active gel for tough trees, shrubs and vines
Contains: 44.7g/kg picloram (as the potassium salt) + 4.47g/kg aminopyralid (as the triisopropanolamine salt)
Cut'n'Paste Picloram Plus+ combines two actives from the same herbicide family in a ready-to-use brush-on gel. It's designed for trees, shrubs and vines. Because you only apply it to the cut stem, there's no spray drift.
Weeds Controlled by Cut'n'Paste Picloram Plus+
Best choice for: barberry, blackberry, broom, evergreen buckthorn (Rhamnus), Californian thistle, cotoneaster, gorse, hawthorn, ragwort, nodding thistle, Scotch thistle, winged thistle and wilding pine. (Not effective on maritime or Corsican pine; use Cut'n'Paste Bamboo Buster for those.)
Also works on: agapanthus, Bathurst bur, white and red clover, docks, Himalayan honeysuckle, Japanese honeysuckle, horehound, lantana, manuka, moth plant, woolly nightshade (tobacco weed), Old Man's Beard, Chinese and tree privet, speedwell, sweet briar, tutu, wattle and woolly mullein.
Important - where not to use it
- Don't use in areas where animal or human foodstuffs are grown.
- Don't use in the urban home garden, or on turf or lawns.
- Don't use in pasture where treated plants may be grazed by stock.
- Don't use near waterways, wetlands or plants you want to keep.
- Don't use if rain is due within 12 hours.
For leafy weeds near garden beds, use Cut'n'Paste Original instead.
Directions for Use - Cut'n'Paste Picloram Plus+
Cut stems horizontally 20 to 100mm above the ground and immediately apply a 3-5mm layer of gel over the whole cut surface. On trunks wider than about 150mm, cut a series of blazes around the main trunk and fill them with gel. On multi-stem plants, treat at least 80% of the stems, including all the main ones. Re-treat any regrowth.
Use with caution
Picloram and aminopyralid are ground-residual. Residues can stay in the soil for at least six months and can harm nearby plants, including natives, if gel gets onto them or into the soil where their roots reach. Wear gloves and follow the label.
Always read the label before use. Results can vary with the size and maturity of the weed, the time of year and how much gel is applied. If you're not sure whether Picloram Plus+ is right for your situation, give us a call on 0508 299 299.
Refer to the Safety Datasheet (SDS) and Label information that can be found on the tabs in this listing.
Common Questions about Cut'n'Paste PicloramPlus+ Gel
How long does it take for the gel to be absorbed into the cut stem?
It depends on the time and the weather. When it is warm and sunny the Cut'n'Paste PicloramPlus+ gets absorbed in up to 4 hours. When it is a bit cooler or the weeds are in damp or sheltered conditions then it can take a few days.
What time of year can it be used?
In New Zealand you can apply the gel at any time but the effectiveness of Cut'n'Paste PicloramPlus+ might be reduced a bit in the colder months.
How many weeds (stems) can I treat from one 450ml bottle of Cut'n'Paste PicloramPlus+?
You should be able to apply to around 240-250 cut stems assuming the diameter of the stem is around 25mm and you are applying a layer of gel around 4-5mm thick.
Can I apply Cut'n'Paste PicloramPlus+ Gel when it's raining?
Not recommended for a number of reasons. Ideally you should not apply when there is risk of rain within 12 hours. Ideally longer to give the herbicide gel a chance to be absorbed. Also if it rains you run the risk of the gel being washed off onto non-target plants.
Is Cut'n'Paste PicloramPlus+ safe around children and pets?
The relatively small amount of active ingredients together with the relatively low toxicity and the small amount being applied to each stem means the product is generally pretty safe but it is still a harmful chemical and must be kept away from children. Especially in the bottle.
Is Cut'n'Paste PicloramPlus+ safe around other plants?
Because you are applying directly to the weed you want to kill there is no spray drift but if you spill small amounts of the gel on non-target plants then they can be damaged. This is the big advantage the Cut'n'Paste Gels though in that you can kill weeds easily without harming other plants and natives.
How often should I replace the brush?
Normally the brush will start to wear out between 5-7 applications so if you are refilling from 5L packs then it is a good idea to buy two brush sets every time you buy a 5L refill pack.
Are there any Cut'n'Paste PicloramPlus+ residues left in the soil?
Yes. Picloram and aminopyralid are ground-residual and residues can stay in the soil for at least six months, so keep gel off the ground and away from the roots of plants you want to keep.
